The MBK-1900 FI (Fully Integrated) is an intelligently designed portable 5G/4 LTE networking system configured with the Cradlepoint R1900 5G/4G LTE modem. These modems support worldwide, SIM-based, auto-carrier selection, CBRS Band 48 and Band 14 FirstNet™.
|Dimensions||14.7 × 10.2 × 6.1 in|
|Number of Devices/Users||
12.8 volt 8 AH (100 Watt hour) LiFePO4 bank
8-14 hours (Estimated)
The MBK-1900 FI (Fully Integrated) is an intelligently designed portable 5G/4G LTE networking system configured with the Cradlepoint R1900 5G/4G LTE modem.
These modems support worldwide, SIM-based, auto-carrier selection, CBRS Band 48 and Band 14 FirstNet™. The MBK-1900 FI provides a WiFi6 802.11 wireless and gigabyte ethernet networking options. The MBK-1900 FI has a custom storage locker and is powered by the 4K Rugged Power Center LifePo4 battery power management system which provides an estimated 8-14 hours of run time.
The MBK-1900 FI is integrated into a mil-spec case with integrated antenna carrier and an internal storage. Ethernet ports are extended to the exterior of the case. Includes one year of limited warranty coverage on all hardware.
MBK-1900 FI is a 5G/4G LTE solution that contains the Cradlepoint R1900 and an integrated LifePo4 battery bank. The Cradlepoint R1900 router is a 5G Embedded High-Performance Solution.
The R1900 mobile router includes an embedded 5G modem that can automatically switch to Cat 20 LTE if the MBK™ moves outside of 5G coverage.
The following features are delivered through the hardware.
Modem: Embedded 5GB NR FR1 low-band, mid-band, and 4G LTE Category 20 modem
Antenna: 4 x SMA cellular antenna connectors
Ethernet: 4 x GbE RJ45 (LAN/WAN switchable)
Wi-Fi: Dual-radio, dual-band, concurrent operation (2.4 GHz & 5 GHz)
Bluetooth: Embedded Bluetooth 5.1 (10 dBm max)— 1 x R- SMA connector.
GNSS/GPS: 1 x SMA GNSS antenna connector
R1900 5G Bands: n1, n2, n3, n5, n7, n8, n12, n20, n25, n38, n40, n41, n48, n66, n71, n77
MBK-1900 FI’s are designed for locations with good 5G/4G LTE signal strength and quick deployment. No external antennas are required.
The internal three stage charge controller will accept 14-18 vdc and up to a 60 watt solar panel. The included wall charger will charge the system in approximately 90 minutes. The internal Battery Protection Circuit prevents overcharge, over-discharge, and short circuits. The volt meter continuously displays the system voltage, and reacts to confirm solar or AC charging. The USB driver is independent, switched, and is 3 amps.